Necessary flying materials:
♪ Bisher of three flowers No. 10 (A, B, B)
♪ Bizarre Number 6
- Suck.
♪ Column 2 s
- 2 beads 6x8 mm tone to biceer
♪ Connective rings 6 mm
- 2 jewelry boxes 4 cm
- Bicellow No12.
♪ Limit for a biser 0, 1 mm or mono
♪ Tools: round-pumps, slices, tonics, scissors
1. Let's start the skiing, secure the end of the thread. Next, we're going to pick up B.C. No. 6, B.E. No. 10, and we're only 7, and we're going up in 3 B.S. No. 6. We'll get 1 bis. Nos. 6 and 7 bis. Column A and revert to the bottom up through the last three major basserinas, thus moving up to 1 bisereen No. 6. We continue to fly so far as the required length, the colour basser A (Figure 1).
2. The second stage is the inflection in the same way as the colour B biser. We begin the same way upwards through three large bicers and pick 7 bis. The colour B moves up the chain, each shifting to one large bicerine upwards (Figs 2-3).
3. Phase three, it's an incursion in the same way. colour bis B, as a result, you'll be able to make a triple burn.
4. I've got to lay the ends and tie the plug, so I've gone through the last two bicers (Figure 6), and I've got the hook and I've wrapped the plug (Fig. 7), so the anchorage has been strong and reliable. We're going to wear the bush, cut it loose, leaving the end of the pin 10 mm and seal the loop.
Finalization completed (Figure 8). Now, with the connection rings, attach the thug to the plug. I used two rings to get the plug straight.
