I'll give you a few tips for our craftsmen, because in the west, the necessary materials for the bracelets are much easier to find! All the advice to do business for yourself, not for sale! I'm a confessionist, so I think if you're gonna sell your work, you're gonna make them the best.
♪ Bracelet form
I'm using the ready forms ordered from the U.S., unfortunately, other quality forms I haven't found. But if you decide Make a bracelet. - a form can be cut out of a metal sheet. You can ask for help from the roofers themselves, you can't refuse to work for a little reward! I want you to paint and cut out of a hard paper the form that cuts the bracelet plate. I advise the edges of the plate to cut round form. Calculate the length of the plate, consider that the inner side of the bracelet will be stitched by the bracelet or skin, which will slightly reduce the size of the completed bracelet. Also, by cutting the paper form, you'll consider that the bracelet itself will slightly increase its length! Remember these factors, calculate the right length of the plate, and also consider that the gap between the edges of the bracelet for convenience should be at least 2.5-3cm. I'm ready, cutting your plate, and you'll only be able to smash your wrist.

♪ Basis for the basser.
I'm sending my bracelets on the basis of Lacy's stiff stuff. It's a great thing, though it's expensive.
If you make a bracelet for yourself, not for sale, you can use the next board, so I threw my second bracelet.
First of all, don't ever leave on a fabric basis, especially on a stretcher! It's not gonna be good, it's personal. My first bracelet, dripping on the tissue and gifted cousin, finally stretched out, almost a year later!
We've unfortunately got a small choice of materials, and there's almost no choice... So I'm sharing my know-how with you. ♪ ♪
We take a normal TERMOCLEY fluid (if your bracelet is done in dark tones, take the gray or black fluid if in bright tones white, but the fluselin can and can be painted with textile paint) and cut five to six straight-angles so that they can be longer than your metal shape by 2.5 cm and wider on the same. We put three rectangles on each other at a level so that the glue side (that is blissite) of one rectangle lay on the other's nycleical side. The next three rectangles are folding the same way, then connect these two sets so they can touch the glue parties!
(example of glue, glue top, glue top, glue to bottom, glue to bottom). I hope you understand.
Next, we put the whole "sandwich" on a piece of paper, A4 will go over and cover the second sheet A4. We're having a nice, hot cliff without a couple. We're turning on the other side, we're going very carefully so that the glue on the fluselina can get pretty and the layers stick together. Let's roll up a very hot cliff, don't be afraid to burn the fluid, that's not gonna happen. You go through the paper! By promulgating the basis, don't touch her until she's completely cold, or she remembers, you don't need to!
That's it. The blackest job is done!